I am failing IP_DUP_RPC_I&M_EPM - Scenario 2 because my udp port number is not being set correctly. When I look at the documentation for this test it says it is checking for "RPCPortNumber <= 0xC000". When I look at the failure message from the Automated RT Tester software it says &qu...

I am failing IP_DUP_RPC_I&M_EPM - Scenario 2 because my udp port number is not being set correctly. When I look at the documentation for this test it says it is checking for "RPCPortNumber <= 0xC000". When I look at the failure message from the Automated RT Tester software it says &quo...

I am currently working on defining the I/O submodules of a Profinet IO device. From what I understand, modules typically correspond to physically pluggable components, while the definition of submodules within a module is generally left to the device manufacturer's discretion. Source: https://refere...

I read in the ProductDocumentation.pdf file of the AutomatedRtTester_V2.45.0.2 folder from the PN-Test bundle that "Device B must be one of Scalance X204 IRT/ Scalance X202-2P IRT" and "Device D/E must be an ET200SP or ET200MP". I was not sure if that meant that I would need to ...

I read in the ProductDocumentation.pdf file of the AutomatedRtTester_V2.45.0.2 folder from the PN-Test bundle that "Device B must be one of Scalance X204 IRT/ Scalance X202-2P IRT" and "Device D/E must be an ET200SP or ET200MP". I was not sure if that meant that I would need to p...

I want to ensure that my intended use of the Profinet Community Stack is allowed under the Community Stack License. I understand it as allowing my company (a PI member company) to use and adapt the code within the Community Stack to create a Profinet adaptation layer for our hardware, then use that ...