Automated RT Tester / Behavior_-Scenario_10(CLRPC) failed
Replies: 2

Help Needed with Pre-Testing Two-Port PROFINET Device Configuration
Replies: 3

When I use the balenaEtcher to flap, I almost always get an error message that the verification did not work, is that ok
Replies: 1

Is there a CLI (command line interface) for automation integrated in the ART Tester?
Replies: 1

Is it possible to test the CDML for controllers with the GSD Checker?
Replies: 1

What is your recommendation to have more than one Version of ART installed?
Replies: 1

What do I have to consider when testing the ART of a 1-port device with regard to the MAC and the settings?
Replies: 1

Controller tests and necessary exchange of information between ART Tester and DUT
Replies: 1

What is meant by 'automated comparison of test results' with respect to the CLI in ART?
Replies: 1

Is a special PC network card needed for running the certification tests based on ETS?
Replies: 1

What are the requirements for the PC, operating system and network card for ETS setup?
Replies: 1

Can the ART Tester handle only the latest GSDML file version, or is it downward compatible?
Replies: 1

To certify a PROFINET controller a file (comparable to the GSD file) is needed. Where do I get this file from?
Replies: 1

Is it planned to release a Linux-compatible version of the Automated RT Tester?
Replies: 1

ART Tester behavior with own Power Outlet DLL
Replies: 2